Running Osnap 运行捕捉模式
Every time you create an object you are required to specify a point or location
It is critical that these points be defined accurately if you expect your drawing to be accurate
Effect of Not Using Object Snaps
Small Circle: look like 2 lines touching each other
Big Circle: Zoom in - 2 lines apart from each other
Settings
1. Right-click on Osnap button
2. Select the Osnap
But each time only can set an Osnap
Osnap - Right-click - Settings...
Set multiple Osnap with the dialog box
Never turn all the object snap modes on at once
It is better to have several object snaps chosen
Osnap only available after command prompts for a point
Can add to or subtract from your object snap modes without exiting a current command
No comments:
Post a Comment